electronics

Articles tagged electronics in octomy

  • 60-40 vs 63-37 Solder.
    04 September 2017

    Today I learned a cool thing about soldering. Solder is usually 60% Tin, 40% Lead, and this is referred to as 60-40. When the solder joint cools, the different…

  • Wheeled rig update
    10 January 2017

    Just a quick update on the wheeled rig. Electronics are starting to come together. Power bar created. Main power bar was created and connected to battery…

  • Wheeled rig update
    27 December 2016

    So I put in some time on the wheeled rig : OctoMY™ Wheeled rig with speakers, buzzer, warning light and electronics mounted. Side closeup showing the battery…

  • 4-Wheeled rig build
    18 October 2016

    I currently have 3 "rigs" I want to integrate OctoMY™ with. The hexy hexapod robot from arcbotics has been featured a few times before on this blog, but the…

  • Water cooled servo
    17 March 2016

    I came over this really innovative solution to a common problem in robotics, namely the lack of power. The hopelessly American solution as employed by robotics…

  • Choice of interconnect
    29 December 2015

    I have been looking at different ways of connecting the different tiers of the robot that facilitates the following characteristics: Real-time Fault tolerant…

  • Hybrid BLDC ESC & GX25 ECU
    28 December 2015

    I have advanced my thinking about the power train. More specifically the details for the board that will handle generator stage has converged somewhat. This is…

  • Solar energy for cheaps
    13 July 2015

    The robot will need all the power it can get, and solar panels has been a part of the plan from the start. However, two problems with solar power has been…

  • Unboxing (unbagging)? of IOIO OTG
    06 July 2015

    This is my second IOIO OTG. The first one was DOA. UPDATE: DO NOT ORDER THESE, they were all DOA. Recommended supplier of IOIO is sparkfunn and seeedstudio…

  • EMCO F1P Step motor specs
    05 April 2015

    After my last post I have learned a lot about step motors. I have also manged to figure out the specs of the step motors found in the EMCO F1P, and as always…