Limb prototype v2.0 hip joint

• Mr. Developerdude

I continued with my limb prototype and added a hip joint. It isn't the most clever design ever but it sort of works as intended. I have learned that joints are hard to get right because:

  • The gears in the motors add slack that make the limb "wobble".
  • The motor axle needs some kind of reinforcement to be used in a joint. In the prototype I just used the axle and nothing more, but I should look into ways of adding support on the back in addition to the axle, and probably add some bearings to add support.
  • The geared motors are very long, and it is hard to conceal them in a normal limb body.
I flattened the other end of the femur and eyeballed out places fo the screw holes.
I drilled the holes and found some more screws that would sit in plastic.
First two screws in place.
All 4 screws in place.
I decided where to attach the axle wheel to the motor bracket in the hip.
I marked where to drill holes.
Two holes drilled.
Wheel securely attached. I decided to just have 2 screws in this prototype.
Motor attached again.
Tadaa! Complete limb with knee and hip joint.